Hydraulic Flame Pipe Cutting Machine

Product Detail

?Key Components Introduction

Description	Specification	Note
Chuck	3 Jaws Chuck
Pipe support bracket	Scissors type bracket	manufacturer
Flame cutting torch	1set	manufacturer
Plasma cutting torch	Hypertherm Powermax105	Made in USA
Driving motor	Panasonic AC servo motor	Japan Brand
Driving control system	Panasonic Driver	Japan Brand
Gear Box	SEW	Germany Brand
Torch Height Sensor	Photoelectric Height Sensor	manufacturer
Controller
Brand	ADVANTECH
CPU	Intel Pentium 1.6Gz
Touch screen	10 inch Color Touch screen
RAM	DDR2 1 GB	Made in Taiwan
Hard Disk	250GB
Operation system	Microsoft Windows XPe/XP Pro
Network card	2 x 10/100/1000 Mbps (RJ-45)

Power supply: 3×380v±10%/50Hz /220v±10%/50Hz(according to client's requirement)

Oxy-fuel cutting gas requirement: 

Gas type: Propane/acetylene/LPG                   Working temperature: -10°C -45°C   

Fuel gas pressure: 0.05-0.1 MPa                     Humidity: <90%, no condensation 

Cutting oxygen pressure: 0.5-0.8 MPa             Surroundings: Ventilation, no big shake

Pre-heat oxygen pressure:0.4-0.6 MPa

Plasma cutting Compress air pressure requirement :

Gas flew requirement:0.9m3/min

Gas pressure:8.3Kg/cm2

Dew-point temperature not exceed 5 centigrade:Oil content=0.003ppm /solid particle=0.01micron

Suggested using oil free air compressor, freezing dryer and ultra filter(system cannot have rust components)